全球鋼材百科網
AW3簡介

牌號 AW3
對應標準 BS 3100-1991
一般工程用鑄鋼件
Specification for Steel castings for general engineering purposes
歸類 鑄鋼
標簽 碳鋼鑄鋼 耐磨和表面硬化用鑄鋼
AW3 化學元素成分含量(%)
成分 C Si Mn P S Cr ② Ni ② Cu ② Mo ② 其他合計
最小值 0.5 - - - - - - - - -
最大值 0.6 0.6 1 0.05 0.05 0.3 0.4 0.3 0.15 0.8
其他單個或其他合計化學成分包括表中未指定值的化學成分。只有在假定存在或在常規分析中，且有跡象表明其成分將超過規定值的情況下，才應進行分析。 ①碳含量每降低0.01%，最大錳含量則增加0.04%，允許最大錳含量到1.1%
②殘余元素。 碳當量計算
AW3 機械性能
熱處理或狀態
抗拉強度
σb
Mpa 		屈服點
σs
Mpa 		斷后伸長率或延伸率
δ
%
A或N或N+T ≥690 ≥370 ≥8
A=for anneal by heating to a temperature above the AC3 and cool in the furnace
N=for normalize by heating to a temperature above the AC3 and cool in still air
OQ=for quench into oil from a temperature above the AC3
WQ=for quench into water from a temperature above the AC3
AH=for air harden by heating to a temperature above the AC3 and cool in air at a rate fast enough to produce a hardened microstructure
T=for temper by heating to a temperature below AC1
ST=for solution treat by heating to temperature high enough to dissolve and any intermetallic phases followed by a rapid cool.
近似對照表 鑄鋼
中國 日本 德國 英國
GB JIS DIN EN/DIN W-Nr. BS EN/BS
ZG40Mn SCMn3 GS-40Mn5 1.1168 AW3
全球鋼材百科網